Ethanol byproducts still pay their way in feedlot rations
by Lyndee Stabel
Paying the feed bill has cleaned out bank accounts faster than Jesse James in recent years, as high corn prices left cattlemen everywhere looking for the cheapest, most efficient alternatives.
Answering that search, Galen Erickson shared research results and insight on distillers grains at the Feeding Quality Forums in Omaha, Neb., and Garden City, Kan., in August.
As of late summer, the ethanol byproducts were selling at near corn prices. Many cattlemen responded by cutting back or removing it, but Erickson, feedlot Extension specialist at the University of Nebraska-Lincoln, said that could be a mistake.
Ethanol plants remove starch from grain, he explained, thus concentrating the remaining protein, oils and minerals in byproducts that have nearly three times the amount of those as corn.
“No matter how expensive it gets, it’s still an inexpensive protein source,” Erickson said. He suggested lowering the amount of distillers grains in a diet to no less than 15% to lower input costs while maintaining a relatively cheap protein supplement.
After reviewing research on feeding performance, he explained there are three common forms to consider.
All ethanol plants produce wet distillers grains and solubles, frequently mixed together (WDGS). Some plants partially or completely dry the WDGS, producing modified distillers grain (MDGS) or dried distillers grains (DDGS). These three products start out the same way, but feeding performance differs.
Research has studied performance of all three in comparison to dry-rolled corn in feedlot rations.
“Wetter is better,” Erickson said as he went over the results. With diets including 30% distillers grains, WDGS had the most value at approximately 137% that of corn.
During his presentation in southwest Kansas, Erickson warned of local exceptions because of steam-flaked corn fed in the region rather than dry-rolled corn. Research showed performance of WDGS was distinctly lower in a steam-flaked ration: gains decreased when more than 15% WDGS were added to the steam-flaked diet, while feed conversions stayed the same.
“So how you process the corn appears to dramatically impact the value of distillers relative to corn,” he said. “If you’re in an area where you have access to a lot of distillers grains and you’re planning to feed 20% or more, I would not recommend flaked corn.”
For those feeding a steam-flaked diet, Erickson offered another option. He found feed-to-gain ratios and average daily gains could be improved by including more solubles in the ration.
Most rations that contain solubles have no more than 10%. But if the price is right, Erickson would double the amount. Research showed optimum gains and conversions when 18% to 27% solubles were included. That may change the appearance of the feed, he added. “But cattle don’t really care what the diet looks like.”
Nearly half the ethanol plants across the U.S. have added a new step in processing: to cut back on tonnage shipped out, they spin off a third of the oil from those soluble first.
Erickson expected that to decrease feeding performance but was surprised by research results that showed no large impact. So far, studies show a range of 1% improvement to a 3.5% decline in performance depending on the setup, and results will be monitored over time.
Producers often ask if distillers grains in a ration require changes in roughages or additives, but the Extension specialist said to manage the same as any grain-based diet.
One concern associated with feeding a high level of distillers grains is that one of the concentrated minerals is sulfur. Too much of that can lead to polio in cattle. But the Nebraska research often feeds cattle much higher levels of distillers grains than any commercial operation would.
“So if there’s going to be any polio, we should see it,” Erickson said, noting they have seen 28 cases out of 17,000 head finished in the past seven years. Summarizing that data, he concluded as long as an operation is feeding less than 40% distillers grains in the diet and the water does not have high levels of sulfur, there should be no problems with polio.
The Feeding Quality Forums were sponsored by Certified Angus Beef LLC (CAB), Feedlot magazine, Purina Animal Nutrition, Roto-Mix, and Zoetis. More details and coverage at stg-cabcattle-staging.kinsta.cloud.
You may also like
Feeding Better Cattle Better
Not everyone is cut out to be a cattle feeder. It’s an art and a science that comes with a need to overcome risk. Wayne Carpenter fed his first pen of steers in 1980 and lost money. But he stuck with it. Today with their sons’ families, he and wife Leisha run the 15,000-head-capacity Carpenter Cattle Company.
FQF: High-Quality Beef Production Takes Focus
The world has changed, cattle have changed and those managing them must keep up. The 19th annual Certified Angus Beef Feeding Quality Forum in Dodge City, Kan., gave 260 attendees tools and information to do just that.
More Than A Meat Scientist
On the surface, he’s a meat scientist. Others know him as a meats judging coach. Some call him “the father of instrument grading.” To those who’ve worked most closely with him, Dr. Glen Dolezal is much more.